Skip to content
Casselberry · Seminole County
Aluminum Wiring Evaluation

Aluminum Wiring Evaluation in Casselberry

ZIP codes
3270732730

Evaluation and CPSC-recognized repair options for 1965–1973 aluminum branch wiring.

Illustrative image

About this service in Casselberry

Some homes built or modified between 1965 and 1973 have aluminum branch-circuit wiring. If an inspector or insurer flagged it, or you’re not sure, we’ll connect you with an independent electrical contractor who can evaluate it and explain the options.

Casselberry grew quickly in the late 1960s and early 1970s, so homes built or rewired between 1965 and 1973 may have aluminum branch circuits. If your insurer flagged it, an electrician can confirm the wiring type, check the condition of the connections and explain whether a connection repair or rewiring makes sense.

Permits

In Casselberry city limits, permits go through City of Casselberry building department. Outside city limits, through Seminole County Building Division (Building Permits Online). The contractor normally pulls the permit.

Close-up comparing silver-coloured aluminum and copper household wires
At a glance

Casselberry

County
Seminole County
ZIP codes
3270732730
Permits inside city limits
City of Casselberry building department
Permits outside city limits
Seminole County Building Division (Building Permits Online)

Signs and situations

Which homes may have it

The U.S. Consumer Product Safety Commission says homes built, or circuits added, between 1965 and 1973 may have aluminum wiring. Homes built before 1965 are unlikely to.

Why it matters

CPSC research found aluminum-wired homes far more likely than copper-wired homes to have connections reach fire-hazard conditions. The risk is at the connections.

Service wiring is different

Large aluminum service and feeder conductors are common and acceptable when properly installed. The concern is small branch circuits.

Insurance

Many Florida insurers ask about single-strand aluminum branch wiring on 4-point inspections.

Call about Aluminum Wiring Evaluation

Repair approaches described by the CPSC
ApproachWhat it isCPSC view
Rewire with copperReplace aluminum branch circuitsPermanent repair
COPALUM crimpCopper pigtail crimped with a special toolPermanent repair (CPSC-recommended method)
AlumiConn connectorSet-screw connector for copper pigtailsAcceptable alternative
CO/ALR devicesAluminum-rated outlets and switchesIncomplete repair at best

Before you hire

  • Ask for the Florida license number and check it on the DBPR license search
  • Ask whether a permit is needed and get the permit number
  • Get the estimate in writing, including what's not included
  • Make sure the final inspection passes and the permit is closed

Frequently asked questions

Look at cable jackets visible in the attic, the garage or near the panel for ‘AL’ or ‘ALUMINUM’. The bare wire may look silver rather than copper colored. Homes built, or circuits added, between 1965 and 1973 are the main candidates. Don’t remove outlet covers or handle wiring yourself: an electrician can confirm it safely, and an insurance inspector may already have noted it on a 4-point report.

Still have a question? Call (844) 578-0475

Call for electrical help

ZIP codes
3270732730
Call (844) 578-0475